Custom One Piece Driveshaft - Steel, 4.0 Inch OD, 1480 Series, Slip & Spline
FREE GROUND SHIPPING INSIDE THE USA
(This product does not qualify for international shipping)
| Weld Yoke Material: |
Forged Steel
|
| Tube Material: |
0.083 Inch Wall DOM Seamless
|
| Tube Outside Diameter: |
4.0 Inch OD (Measuring Guide - Tube OD)
|
|
U-Joints:
|
Spicer/Dana 1480 Series Premium Non-Greasable
U-Joint Size: 1 3/8 Inch Cap X 4 3/16 Inch Span
(Measuring Guide - U-Joint)
|
|
Max HP:
|
1500 |
| Max Custom Length: |
Up to 68.0 Inches - Center to Center of U-Joint
|
| Slip & Spline Travel: |
+/- 1.25 Inch |
4.0 Inch Steel Driveshaft
This driveshaft is designed with a 1480 series u-joint on the front and rear.
The driveshaft comes fully assembled, balanced and ready to bolt in. Installation is as simple as bolting up the 1480 series U-joints. You do need to check for clearance when upgrading your tube diameter. Before install check that the new bigger tube wont rub your vehicle. The carrier bearing cross members may need to be removed.
You won't be disappointed with your new heavy duty 1480 series 4.0 inch steel driveshaft. Time and again customers are impressed at how well made the driveshaft is and better yet, how it helps solve vibration and carrier bearing problems - no matter if is a daily driver, over the road towing rig or pulling truck.
Required Driveshaft Measurements:
You can place your order today and we will send a follow up email requesting your driveshaft length or your can submit your measurement below. Measure from the tran. case center of u-joint to the center of the U-joint on the end yoke or to the flat of the flange face on the rear. We cannot complete your driveshaft order until we have your driveshaft length.
If you have any questions we are here to help:
CHAT | PHONE (574)287-9650 | CONTACT US
FREE GROUND SHIPPING INSIDE THE USA
(This product does not qualify for international shipping)
